Vai al contenuto principale
Autoricambi247

Steering Angle Sensor Buying Guide

Ultimo aggiornamento: 24 aprile 2026

The steering angle sensor — abbreviated SAS or steering position sensor — measures the rotational angle and speed of the steering wheel and transmits this data to the electronic stability programme (ESP), electric power steering (EPS), and adaptive headlight systems. The ESP uses the steering angle to determine the driver's intended direction and compare it against actual yaw rate and lateral acceleration, intervening if the vehicle departs from the intended path. A faulty or uncalibrated SAS disables the ESP and EPS assist calibration, triggering warning lights and degrading vehicle dynamics. CarParts247 stocks steering angle sensors from Bosch, Continental, and Hella for a range of modern vehicles.

Symptoms of a faulty steering angle sensor

Because the SAS is safety-critical, the vehicle management system monitors its output continuously and disables dependent systems at the first sign of abnormal data.

  • ESP and traction control warning lights on simultaneously
  • EPS assist feels off-centre or does not provide assistance symmetrically
  • Adaptive headlights no longer pivot with steering input
  • DTC codes C0455, C1145, or manufacturer-specific SAS codes
  • ESP intervenes incorrectly in corners — SAS reading wrong angle

Calibration after replacement

Unlike most sensors, the steering angle sensor always requires a calibration (zero-point set) procedure after replacement. With the vehicle on level ground and the steering wheel pointing straight ahead, a diagnostic tool is used to set the sensor's straight-ahead reference. Without this step, the ESP cannot calculate whether the vehicle is understeering or oversteering and remains disabled.

Calibration is also required after any steering, suspension, or wheel alignment work that changes the straight-ahead steering position.

Category page

  • Browse matching parts

    ESC and traction control faults caused by steering angle sensor errors — calibration requirements, fault codes, and replacement guide.

Related guides

  • Boot and Bonnet Gas Strut Buying Guide

    Tailgate or bonnet not staying up? How to measure force rating, strut length, and ball-end fittings — and why cheap gas struts fail quickly.

  • CV Boot Buying Guide

    Split or cracked CV boots lead to joint failure — how to spot grease flinging, boot types and sizes, and replacing a boot without removing the driveshaft.

  • Guida ai bracci della sospensione

    A cosa servono i bracci della sospensione, sintomi di boccole e giunti sferici usurati, e quando sostituirli sulla tua auto.

  • Guida ai cuscinetti ruota

    Ronzio, rumore sordo, scricchiolio — come diagnosticare un cuscinetto ruota difettoso sulla tua auto e capire le opzioni di sostituzione.

Domande frequenti

Can I calibrate the steering angle sensor without a diagnostic tool?

Not reliably. Some older vehicles allow a manual calibration procedure using ignition cycles and steering inputs, but modern vehicles with integrated SAS units require a tool that communicates with the ABS/ESP module directly.

Will my car pass the MOT with the ESP warning light on?

Yes — ESP is not a mandatory MOT test item on most vehicles registered before ESP became compulsory. However, a vehicle with a known faulty safety system is not in a roadworthy condition for daily use.

Is the steering angle sensor inside the steering column or the steering rack?

Usually inside the steering column, typically integrated with the clock spring or positioned on the column shaft just below the steering wheel. Some vehicles use a sensor at the steering rack pinion instead.

Can a steering angle sensor cause the car to pull to one side?

Not directly — the SAS inputs to the ESP, not the power steering rack. However, a miscalibrated SAS causes the EPS torque assist to be applied asymmetrically, which can feel like a very mild pull.

Guide correlate

Pronto a trovare il ricambio giusto?

Sfoglia i ricambi auto